2. GRAPH PAPER: the quarter-inch grid is what will be used to draft a pattern, unless you want to try and use the computer.

3. TRACING PAPER: for sketching and protecting colors.

4. FOAM CORE BOARD: This is the type of board that is used to back art work to make it sturdy for framing. It should be cut to 9"x 12". I usually have to use the 1/4" foam core board and tape 2 pieces together.  You may be lucky to find the 1/2" board.  You do not want the pins to go through the bottom of the board.  You can find foam core boards at art and office supply stores.

5. TAPE:  Used to tape boards together. The pattern will need to be taped down.

6. BANK PINS. These are #24 gauge, stainless steel, 1 1/2" pins.  They are called bank pins.  Also available at office supply stores. These pins are used to create the outside edge of your necklace design. The warp threads are wrapped around these pins.  Regular pins are to thin and will bend when weaving.  

7. WARP THREAD.  (Vertical threads) 18-gauge #2 and #3 ply, waxed linen carpet thread.  If you are planning a light colored necklace use light and if dark necklace use dark.  Most of the warp thread will be covered with the weft thread.

8. WEFT THREADS.  (Horizontal threads) I like to use #3 or #5 Perle Cotton, it's available in many beautiful colors.  The larger #3 thread is thicker and makes a thicker necklace and goes faster.  Other threads work well such as silk, perle rayon and other synthetic thread that is similar in weight.  Make sure you aren't allergic to wool.  Small amounts of metallic threads add a special touch.

9.SCISSORS: Small needlework scissors.

10. TAPESTRY NEEDLES: The best needles for this project are #18, #20, #22 tapestry needles, they have a smoother point.  I like to heat the needle to remove the temper so it can be slightly bent.  You have to wear safety glasses when doing this.  Be careful!  You can find curved UPHOLSTERY NEEDLES at craft and sewing stores, but sometime they flip around to much.

11. NEEDLE-NOSE PLIERS: Pliers make it easier to grab the needle when it gets in a tight weaving area.  

12. BEATER: (SMALL TABLE FORK) You need this to pack the weft threads tight.

13. BEADS: This is the fun part, the hole must be large enough to slide onto the waxed linen (double warp thread).  Smaller beads (less than 1/2") diameter fit between the warp threads best.  The beads hanging at the bottom of the weaving can be larger.  Almost anything that is perforated, or can be perforated will work. Many collectible items look great as center pieces or focal points.  Be sure and check your beads first to see if they will fit on two strands of the size waxed linen you are using.

14. MONOFILAMENT: This is used as a needle for small beads.  It helps to thread beads on the waxed linen warp (vertical threads).

15. CROCHET HOOK: Size #12 or #13 will work if the bead holes are large enough.

16. FRAY CHECK: Found at craft and sewing stores.  It is used to prevent fibers from fraying.

17. COLORED PENCILS: Can be art pencils or marker pencils.

18.THIMBLE: Help protect you fingers.

19. PATIENCE: This takes time but it is worth it.

Thank you for your interest in "Needleweaving and I hope you enjoy learning this new and exciting art.